84 Sun StorageTek 2500 Series Array Hardware Installation Guide • September 2009
▼ To Install the SAN 4.4 Data Host Software
To launch the host software installer:
1. Log in to the host as root.
2. Change to the SAN_4.4.xx_install_it directory in which the compressed
installation file was unpacked:
cd <user-specified location>/SAN_4.4.xx_install_it
3. where xx is the software version number of the installed files. Start the host
software installer by typing the following command:
./install_it
When the installation is complete, the root prompt returns.
Note – It might be required that the host be rebooted into single user, and then
rebooted right afterward to multiuser.
4. Enable the Sun StorageTek Traffic Manager multipathing software (see
“Enabling Solaris Multipathing Software” on page 86).
▼ To Obtain Software for Operating Systems Other
Than Solaris
1. Go to the Sun Microsystems web page (sun.com).
The Sun home page is displayed.
2. Select Downloads from the home page navigation bar.
The Downloads page is displayed.
3. On the View by Category tab, scroll down to select System Administration >>
Storage Management.
The Storage Management page is displayed, showing a list of downloadable
storage-related products.
4. Scroll down and select the StorageTek 2500 Series multipath/failover option for
your particular operating system.
The login page is displayed.
5. Login using your Sun account ID.
The product Download page is displayed.
To Next Page
Loading...
Need help?
General
