138 Sun StorageTek 2500 Series Array Hardware Installation Guide • September 2009
d. Click OK.
After the configuration process has finished, the DHCP server provides BOOTP
services to the MAC address you entered for each controller.
9. To verify that the BOOTP service is running, go to Service >> Restart.
10. After you power on the storage array, ping the address.
If the ping responds with ‘alive’, the DHCP server BOOTP operation was successful.
Setting Up a Windows 2000 Advanced
Server
Before you begin, make sure the following requirements are met:
■ Windows 2000 server and the storage array are both on the same subnet.
■ IP addresses that are assigned to the controllers do not conflict.
To Next Page
Loading...
