Chapter 9 Configuring IP Addressing 95
5. Select option 1, Display IP Configuration, to confirm the IP address changes.
The IP address configuration of the Ethernet port is displayed, and the Service
Interface menu displays again.
6. Press Q to quit the Service Interface menu.
7. Switch the serial cable to the serial port on the other controller and repeat these
steps to set the IP address on that controller as well.
8. Power cycle the controllers off and on again to reset them with the new IP
address.
When you have completed the IP address configuration for the Ethernet port on
both controllers and power cycled them, see the Sun StorageTek Common Array
Manager Software Installation Guide for instructions on registering and configuring the
storage array.
Service Interface Main Menu
==============================
1) Display IP Configuration
2) Change IP Configuration
3) Reset Storage Array (SYMbol) Password
Q) Quit Menu
Enter Selection: 1
To Next Page
Loading...
Need help?
General
