110 Sun StorageTek 2500 Series Array Hardware Installation Guide • September 2009
i. Note the number of disks (volumes) before you configure new volumes.
#format
AVAILABLE DISK SELECTIONS:
0. c3t0d0 <SUN72G cyl 14087 alt 2 hd 24 sec 424>
/pci@8,600000/SUNW,qlc@4/fp@0,0/ssd@w500000e010483de1,0
...
3. In the CAM software:
a. Create each initiator with its IQN from the data host noted in Step 2a.
Refer to “Adding Initiator Information” on page 103 for details.
b. Follow CAM documentation to:
■ Create a volume
■ Map the volume to a host or host group linked to the initiator.
4. On the data host:
a. Create the iSCSI device link on the data host.
#devfsadm -i iscsi
b. Issue the format command and verify that more disk (volumes) were created
than what you noted in Step 2i.
#format
The system is ready for you to use system administrator commands to create and
mount a file system.
To Next Page
Loading...
