Sun Microsystems 2500 - Turning Off the DC Power During an Emergency; Relocation Cautions

Appendix C iSCSI Configuration Example Using Windows 119
11. In the Advanced settings tab, select local adapter as the Microsoft iSCSI
Initiator.
12. For source IP, enter the system IP where the initiator is running.
13. For target portal enter the IP address you have discovered in the previous step.
14. Click OK.
After this, the status of the target should be shown as Connected.
15. Repeat Steps 7 to 14 for each target (minimum one target per controller).
16. In the Common Array Management software, configure the following using the
Common Array Management documentation (Install Guide or online help) to:
■ Create volumes
■ Map each volume to a host or host group linked to an initiator.
17. Launch the Computer Management application in Windows and open Disk
Management.
You should be able to see the mapped volume on your host.