Index 153
establishing communication between a terminal and
a controller serial port, 92
Ethernet connection
controller trays, 9
Ethernet ports
connecting directly to management host, 57
connecting to a management LAN, 56
connecting using a hub, 56
expansion tray
ship kit contents, 30
F
fabric topology, 60
fans
power-fan assembly, 14
fault LED, 21
Fibre Channel
ST2540 controller tray, 10
firmware, 10
front-access tray components, 5
H
host
cabling to a 2510, 59, 121
cabling to a 2530, 63
cabling to a 2540, 69
connecting for management, 55
setting up a data host, 82
hot swap
controller CRUs, 9
I/O module, 14
I
I/O module
cabling, 15
ST2501 drive expansion tray, 14
initiator, 98
installation process, 4
installing a tray in a cabinet, 40
installing data host for a non-Solaris host, 86
installing data host software for a non-Solaris
host, 86
installing data host software for non-Solaris
host, 83, 85
intertray cabling, 45
1x2 configuration, 48
1x3 configuration, 49, 50
IP addressing
about, 89
configuring DHCP, 90
configuring for array controllers, 89
configuring static, 91
using the controller serial port, 91
iSCSI
configuration, 97
definition, 146
session, 98
Solaris example, 107
target, 98
Windows example, 111
iSCSI initiator, 98
iSCSI Qualified Name (IQN), 101
L
LEDs
fault, 21
on the front of the trays, 6
on the rear of the ST2510 controller tray, 16
on the rear of the ST2540 controller tray, 16
on the rear of the trays, 16
power-fan assembly, 19
Service Action Allowed, 21
M
MAC address, 10
MAC address location, 133
management host
connecting, 55
connector cable types, 10
multipathing software
enabling, 86
N
network topology, 60
New Scope wizard, 140
O
out-of-band management, 9
P
part numbers
universal rail kit, 28
To Next Page
Loading...
