Chapter 2 Installing Trays 37
3. Insert and tighten two 8-32 screws through the top and bottom holes in the
adapter plate, through the cabinet rail, and into the top and bottom threaded
holes in the universal rail mounting flange (
FIGURE 2-9).
FIGURE 2-9 Securing the Rail to the Front left of the Cabinet
4. Repeat Step 1 through Step 3 on the corresponding cabinet rail at the back of
the cabinet (
FIGURE 2-10).
Mounting the rail on the back of the cabinet is the same as mounting it to the
front, after you extend the rail the necessary length to reach the rear cabinet rail.
To Next Page
Loading...
