SWDE200B Operation & Maintenance Manual
forced valve open and the light flickers every 1 second,
and then press down that again, the forced valve close
and the light is off.
Start the engine and enable the pilot, the warning light is
on automatically without sound. When reversing, the
sound and light are turned on automatically. Press down
the switch to close the warning light, and press down that
again to enable that. Any function is enabled, the
indicator light on the panel is on, and otherwise, it’s off.
Press down the switch, the indicator light is on,
corresponding water tank heater heat continuously for 30
minutes, and press it again, the indicator light is off, and
the function is disabled. (optional for diesel electric
integrated type/electric type)
Press down the switch, the indicator light is on,
corresponding water tank heater heat continuously for 30
minutes, and press it again, the indicator light is off, and
the function is disabled. (optional for diesel electric
integrated type/electric type)
Press down the switch, the indicator light is on,
corresponding hydraulic oil heater heat continuously for
30 minutes, and press it again, the indicator light is off,
and the function is disabled (optional for diesel electric
integrated type/electric type).
Press down the switch, the indicator light is on and the
dedusting water pump is started.
Function Table：
Button number corresponds to the number on the bus panel. For example: E1 is the left upper
switch on the bus panel, and E2 is the right upper switch, E7 is the left lower switch, and E8 is
the right lower switch.
To Next Page
Loading...