16. Rear Wheel / Rear Fork / Rear Cushion
16-2
Precautions in Operation
General Information
Please refer to the Maintenance Manual for tubeless tire in respect to the removal, repair and installation
of the tires.
Service data Unit: mm
Item Standard Allowable Limit
Radial - 2.0
Run-out of rear rim
Axial - 2.0
Torque Value
Rear wheel axle nut 11.0~13.0kgf-m
Rear cushion upper bolt 3.5~4.5kgf-m
Rear cushion under bolt 2.4~3.0kgf-m
Rear fork mounting bolt 4.0~5.0kgf-m
Exhaust muffler mounting nut 1.0~1.2kgf-m
Exhaust muffler mounting bolt 3.2~3.8kgf-m
Brake clipper mounting bolts 2.9~3.5kgf-m
Brake disc mounting bolt 4.0~5.0kgf-m
Troubleshooting
Run-out of rear wheel
z Deformed or bent wheel hub.
z Improper tires.
z Loose wheel shaft.
Soft Cushion
z The spring is too weak.
Noisy Brake
z Worn brake lining.
z Offset brake disc.
z Improper assembly of brake caliper.
z Brake disc or wheel imbalance.
Poor Performance of Brake
z Improperly adjusted brake.
z Contaminated brake disc.
z Worn brake lining.
z Air inside brake fluid pipe.
z Grease on brake disc.
z The brake fluid piping is clogged.
z The brake fluid pipe is deformed or bent.
z The brake fluid pipe is deformed or bent.
z Insufficient amount of brake fluid in the reservoir
To this chapter contents
To Next Page
Loading...
Need help?
General
