2. Maintenance Information
2-12
Brake Light Switch / Start Switch
The brake light switch is to light up brake lamp as
brake applied.
Make sure that starter motor can be operated only
under brake applying.
Headlight Distance Adjustment
Turn on main switch
Headlight beam adjustment. Turn the headlight
adjustment screw to adjust headlight beam high.
Caution
y To adjust the headlight beam follows related
regulations.
y Improper headlight beam adjustment will make
in coming driver dazzled or insufficient lighting.
Wheel / Tire
Caution
y Tire pressure check should be done as cold
engine.。
Appointed tire pressure
Tire size Front tire Rear tire
Load for
under 90 Kg
1.75 2.25
Tire pressure as
cold engine
(Kg/cm²)
Full loaded 1.75 2.50
Check if tire surface is ticked with nails, stones or
other materials.
Check if front and rear tires’ pressure is in normal.
Measure tire thread depth from tire central
surface.
Replace the tire if the depth is not come with
following specification
Front tire：1.5 mm
Rear tire：2.0 mm
Stop switch
Headlight beam adjustment screws
To this chapter contents
To Next Page
Loading...
