EasyManuals Logo

Sym RV 250i User Manual

Sym RV 250i
275 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #93 background imageLoading...
Page #93 background image
4. Fuel Injection System
4-44
Fault Code and Check Light Flashing Lighting Identification Table
No.
Fault
codes
Fault Description
Check
light
Check light flashing
state
Parts Inspection
Throttle position sensor fault Lighting
long 0short 6
Throttle position sensor and wire
1 0120
Fault detection procedures Please refer to the "EFI System components description" throttle position sensor
(TPS) chapter
Manifold Absolute Pressure sensor fault lighting
long 0short 9
MAP sensorand wire
2 0105
Fault detection procedures Please refer to the "EFI System components description" manifold Absolute
Pressure sensor (MAP) chapter
Engine temperature sensor fault (water) lighting
long 1short 2
Engine temperature sensor and wire
3 0115
Fault detection procedures Please refer to the "EFI System components description" engine temperature
sensor (WPS) chapter.
Engine oil temperature sensor fault (oil) lighting
long 1short 1
Engine temperature sensor and wire
4 0195
The current reservation
Intake temperature sensor fault lighting
long 1short 3
Intake temperature sensorand wire
5 0110
Fault detection procedures Please refer to the "EFI System components description" intake temperature
sensor (TAS) chapter.
Roll over sensor fault lighting
long 1short 5
Roll over sensor and wire
6 1630
Fault detection procedures Please refer to the "EFI System components description" Roll over sensor chapter.
O
2
sensor fault lighting
long 1short 7
O2 Sensorand wire
7 0130
Fault detection procedures Please refer to the "EFI System components description" O2 sensor chapter.
INJ #1 fault
lighting
long 3short 3
Injector and wire
8 0201
Fault detection procedures Please refer to the "EFI System components description" fuel injector chapter.
IG #1 fault lighting
long 3short 7
Ignition coil and wire
9 0351
Fault detection procedures to adhere to the traditional way
Fuel pump fault lighting
long 4short 1
Fuel pump and wire
10 0230
Fault detection procedures Please refer to the "EFI System components description" fuel pump chapter.
O2 sensor heater fault lighting
long 4short 5
O2 Sensorand wire
11 0135
Fault detection procedures Please refer to the "EFI System components description" O2 Sensor chapter.
ISC motor fault lighting
long 4short 9
Step motor and wire
12 1505
Fault detection procedures Please refer to the "EFI System components description" idle speed control valve
(ISC) chapter.
Exhaust 2
nd
air solenoid valve fault lighting
long 5short 4
2
nd
air control valve and wire
13 1410
Fault detection procedures Please refer to the "EFI System components description" 2
nd
air solenoid valve
chapter.
Crankshaft position sensor fault lighting
long 6short 6
Crankshaft position sensor and wire
14 0335
Fault detection procedures Please refer to the "EFI System components description" Crankshaft position
sensor chapter.
PM wire fault lighting
long 6 short 8
Manifold absolute pressure sensor
and wire
15 1205
Fault detection procedures Please refer to the "EFI System components description" Manifold absolute
pressure sensor (MAP) chapter.
EEPROM fault Not lit
long –short –
EEPROM
16 0603
This fault Please direct replacement ECU
To this chapter contents

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sym RV 250i and is the answer not in the manual?

Sym RV 250i Specifications

General IconGeneral
BrandSym
ModelRV 250i
CategoryScooter
LanguageEnglish

Related product manuals