Symmetricom 5071A User Manual

Chapter 5 Command Reference
5071A Command Summary
Operating and Programming Manual 75
Table 5-2. SCPI Command Summary (Continued)
Command
Parameter Form
Response Form
Comment
[SOURce]:PTIMe:STANdby
<OFF|0|ON|1>
Sets/resets Standby
mode.
[SOURce]:PTIMe:STANdby?
<0|1>
Returns Standby mode
status.
[SOURce]:PTIMe:SYNChronization
<OFF|FRONt|
REAR>
Arms selected Sync port.
[SOURce]:PTIMe:SYNChronization?
<OFF|FRON|
REAR>
Returns armed Sync
port, if any.
REFERENCE OSCILLATOR COMMANDS
[SOURce]:ROSCillator:CONTrol
<numeric_value>
Sets OSC tune voltage
(in Standby).
[SOURce]:ROSCillator:CONTrol?
[MIN|MAX]
<NR3>
Returns OSC tuning
voltage.
[SOURce]:ROSCillator:STEer
<numeric_value>
Sets fractional frequency
offset.
[SOURce]:ROSCillator:STEer?
[MIN|MAX]
<NR3>
Returns set fractional
frequency offset.
[SOURce]:ROSCillator:FREQuency[1|2]
<frequency>
Sets selected Output-
port Hz.
[SOURce]:ROSCillator:FREQuency[1|2]?
[MIN|MAX]
<NR3>
Returns Output-port Hz.
[SOURce]:ROSCillator:MVOLtage?
<NR3>
Returns OSC-oven
monitor voltage.
STATUS MONITORING COMMANDS
STATus:OPERation[:EVENt]?
<NR1>
Returns/clears OEReg
contents.
STATus:OPERation:CONDition?
<NR1>
Returns OCReg
contents.
STATus:OPERation:ENABle
<numeric_value>
Sets OEReg to specified
value.
STATus:OPERation:ENABle?
<NR1>
Returns OEReg
contents.
STATus:OPERation:NTRansition
<numeric_value>
Sets NTRReg to
specified value.
STATus:OPERation:NTRansition?
<NR1>
Returns NTRReg
contents.
STATus:OPERation:PTRansition
<numeric_value>
Sets PTRReg to
specified value.
STATus:OPERation:PTRansition?
<NR1>
Returns PTRReg
contents.

Symmetricom 5071A Specifications

General

Brand	Symmetricom
Model	5071A
Category	Measuring Instruments
Language	English