Tally T6090 - Page 10

T6090 Maintenance Manual
6
Figure Listing
Chapter 4
Figure 4–1. Disconnecting the Gas Spring.................................................................................... 4–2
Figure 4–2. Removing the Lid ....................................................................................................... 4–3
Figure 4–3. Removing the Control Panel ...................................................................................... 4–4
Figure 4–4. Reinstalling the Control Panel ................................................................................... 4–5
Figure 4–5. Removing the Right End Cover ................................................................................. 4–6
Figure 4–6. Reinstalling the Right End Cover .............................................................................. 4–7
Figure 4–7. Removing the Engine Controller CBA ...................................................................... 4–8
Figure 4–8. Removing the Personality Module CBA ................................................................. 4–10
Figure 4–9. Removing the Personality Module Enclosure ......................................................... 4–11
Figure 4–10. Removing the Fan Assembly.................................................................................... 4–12
Figure 4–11. Disconnecting the Static Ground. and Removing the Sound Deadening Hood...... 4–13
Figure 4–12. Removing the Power Supply.................................................................................... 4–14
Figure 4–13. Removing the Left End Cover ................................................................................. 4–15
Figure 4–14. Disconnecting the Ribbon Platform Components ................................................... 4–16
Figure 4–15. Removing the Ribbon Platform ............................................................................... 4–17
Figure 4–16. Removing the Ribbon Motor ................................................................................... 4–18
Figure 4–17. Disconnecting the Hammer Bank ............................................................................ 4–19
Figure 4–18. Removing the Hammer Bank................................................................................... 4–20
Figure 4–19. Removing the Ribbon Shield ................................................................................... 4–21
Figure 4–20. Removing Hammer Bank Air Duct.......................................................................... 4–23
Figure 4–21. Removing and Replacing the Hammer Module. ..................................................... 4–24
Figure 4–22. Using the Hammer Alignment Tool ......................................................................... 4–25
Figure 4–23. Shuttle Assembly Removal ...................................................................................... 4–26
Figure 4–24. Removing the Platen ................................................................................................ 4–27
Figure 4–25. Platen End Assembies .............................................................................................. 4–28
Figure 4–26. Removing the Platen Open Sensor .......................................................................... 4–29
Figure 4–27. Removing the Shuttle Motor.................................................................................... 4–30
Figure 4–28. Reinstalling Shuttle Motor Pulley............................................................................ 4–31
Figure 4–29. Removing the Shuttle Motion/Capture Sensor ........................................................ 4–32
Figure 4–30. The Shuttle Drive Belt.............................................................................................. 4–34
Figure 4–31. Removing the Paper Drive Motor ............................................................................ 4–35
Figure 4–32. Paper Advance Motor Assembly.............................................................................. 4–36
Figure 4–33. Phasing/Belt Adjustments ........................................................................................ 4–37
Figure 4–34. Phasing Gauge Installation ...................................................................................... 4–37
Figure 4–35. Paper Drive Belt Adjustment ................................................................................... 4–38
Figure 4–36. Removing Upper Tractor Assembly......................................................................... 4–39
Figure 4–37. Upper Tractor Alignment ......................................................................................... 4–40
Figure 4–38. Removing Lower Tractor Assembly ........................................................................ 4–41
Figure 4–39. Lower Tractor Alignment ......................................................................................... 4–42
Figure 4–40. Platen Gap Adjustment............................................................................................. 4–43