Tally T6090 - Serial and Parallel Interfaces; Parallel; Serial; Motorola MC68340

Chapter 1: Electronic Hardware Architecture, Performance & Specifications
1–3
Serial and Parallel Interfaces
Serial
• MC145406 (+/- 12V) chip is used for the RS-232 drivers and receivers
• Internal programmable bps generator (300 bps to 38.4K bps)
• Both DTR/Busy and XON/XOFF is supported
• Standard secondary RTS on pins 11 and 19. Primary RTS is capable of being
jumpered to pin 4
Parallel
• Altera EPM7064 and 74LS374/74LS244 – supports IEEE-1284 compatibility and
nibble modes
Motorola MC68340
• 25MHz clock
• 16-bit CPU bus
• Two direct Memory Access (DMA) channels – One for hammer loading, and one for
the IEEE-1284 parallel Interface
• Two serial channels – One for the control CPU communication, and one for the
external serial interface
Flash Memory
The amount of Flash Memory depends on the configuration of the personality module.
DRAM
The amount of DRAM depends on the configuration of the personality module.
Altera EPM7064
• Dynamic random access memory (DRAM) control
• Logic for IEEE-1284 Parallel interface
• Glue logic (chip selects, hammer data and clock, row and column selection for
DRAM)