8.2 ADJUSTING THE POSITION OF THE SPEED SENSOR
The distance between the speed sensor and the closest screw of the copper disk (making a com-
plete rotation of the disk using a thickness gauge) must be: d = 0.8 ÷ 1.0 mm.
d
Fig. 37
8.3 FRAME ASSEMBLY
8
Fig. 38
TIGHTENING TORQUE of the screws [8] (two for each side): 9 Nm [6.6 lbf-ft].
TECHNOGYM ELLIPTICAL Technical Service Guide
Rev. 1.1
- 134 -
Uncontrolled copy if printed Uncontrolled copy if printed
To Next Page
Loading...
