Technogym ELLIPTICAL - Forcing of the System in Stand-By; Initialization of the Eeprom

6.4.2.9 FORCING OF THE SYSTEM IN STAND-BY
Name  Notes
Forcing of
the system

 @FORCESUSPEND# Forces the equipment to the stand-by
state.
Response: SUSPENDING if the equip-
ment is in IDLE or RESUME status,
even with App connected
 SUSPENDING...
Tab. 21
6.4.2.10 INITIALIZATION OF THE EEPROM
Name  Notes

of the EE-
PROM
 @EEPROMDEF#
 OK or ERROR OK if initialization of eeprom
was successful.
Resets the following data:
-Error log
-HK Life-data
Sets the following info to default con-
dition:
- minimum RPM value
- display brightness
- threshold of the accelerometer
- pause timeout with App connected
- timeout to go from Idle to Standby
- unit of measure
- type of speed (RPM-km/h)
- debug notications disabled
ERROR if initialization of eeprom was
not successful.
Tab. 22
TECHNOGYM ELLIPTICAL Technical Service Guide
Rev. 1.1
- 42 -
Uncontrolled copy if printed Uncontrolled copy if printed