Technogym ELLIPTICAL - Commands; Equipment Serial Number Setting; Serial Number Reading; System Configuration Reading

6.4.2 COMMANDS
6.4.2.1 EQUIPMENT SERIAL NUMBER SETTING
Name  Notes
 
setting
  where:
<id>=serial number
 TG_ID:<id> or ERROR ERROR if the length of the serial
number is less than 14 characters
Tab. 13
6.4.2.2 SERIAL NUMBER READING
Name  Notes
 

 @RTG_ID #
 TG_ID:<id> Prints 0 if no number has been
saved.
Tab. 14
6.4.2.3 SYSTEM CONFIGURATION READING
Name  Notes
 -

 @RMACHINETYPE#
 BIKE TYPE or ELLIPTICAL
TYPE
Prints the system con-
guration.
Tab. 15
6.4.2.4 SELECTION OF THE SYSTEM CONFIGURATION
Name  Notes
Selection of the system

 @SELLIPTICAL#
 ELLIPTICAL TYPE Prints the selected congu-
ration.
Tab. 16
TECHNOGYM ELLIPTICAL Technical Service Guide
Rev. 1.1
- 40 -
Uncontrolled copy if printed Uncontrolled copy if printed