4.6 MOVING THE PRODUCT
The product has xed wheels. To move it, lift the pedal levers up and block them, then lift the prod-
uct slightly as shown in the gure below and push it forwards or backwards.
If the condition of the oor makes it impossible to use the wheels, move the product with normal
lifting and transport methods.
After moving the product, always check it is level to safeguard correct operation.
Fig. 10
TECHNOGYM ELLIPTICAL Technical Service Guide
Rev. 1.1
- 28 -
Uncontrolled copy if printed Uncontrolled copy if printed
To Next Page
Loading...
