TRAÇABILITÉ CRÉATIVE
CREATIVE TRACEABILITY
TECHNOMARK
1 Allée du développement 29
42350 La Talaudière (France)
Tel : +33 (0) 4 77 22 25 91
Fax : + 33 (0) 4 77 22 38 93
E-mail : info@technomark-marking.com
V : SJ Le : 20/06/17 R : DD
www.technomark-marking.com
gives the diameter used in case of a circular marking, in the selected units (mm or inches)
gives text compression from 50% to 150%
gives spacing between characters from 0 to 9
gives the italic inclination of the text from 0 to 9.
gives the number of impact for each marking point, from 1 to 9.
Use key to confirm your modifications.
Use key to cancel your modifications
c) Add a mechanical function
Pressing add a mechanical function key shows the following scrolling menu:
Pause – Set a pause during a marking process
A marking line can have a pause status.
In that case the marking is done for the lines defined before this pause, and then the marking stops
for a pause
To Next Page
Loading...