EasyManuals Logo

Technomark Multi4 V3 User Manual

Technomark Multi4 V3
85 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #68 background image
TRAÇABILITÉ CRÉATIVE
CREATIVE TRACEABILITY
TECHNOMARK
1 Allée du développement 68
42350 La Talaudière (France)
Tel : +33 (0) 4 77 22 25 91
Fax : + 33 (0) 4 77 22 38 93
E-mail : info@technomark-marking.com
V : SJ Le : 20/06/17 R : DD
www.technomark-marking.com
It is necessary to make at least 4 or 5 charge/discharge cycles, to get the full use time of the
accumulators.
The battery kit is protected against over heat (60°C) and short cuts.
Never plug/unplug the battery if the MULTI4 control panel is under power.
Before any replacement operation of the battery, disconnect the power plug and make sure the
control panel is switched OFF.
There is an explosion risk if the battery is replaced by an incorrect type battery. Dispose of used
batteries according to instruction.
Never use a defective battery with your MULTI4.
Exclusively Technomark supplied batteries are compatible with your MULTI4

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Technomark Multi4 V3 and is the answer not in the manual?

Technomark Multi4 V3 Specifications

General IconGeneral
BrandTechnomark
ModelMulti4 V3
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals