3-20
dn-08 (Display Serialized Models)
Users can use
dn-08
to check driver/motor combination set in the driver currently. If the displayed
combination differs from actual condition, please refer to “1-1-3 Matching list of servo driver and motor”
to reset parameter
Cn030
or consult local distributor.
dn-09 (ASIC software version display)
The User can use
dn-09
to know the current ASIC Version of this Device, the Panel Display
Description is as follows:
Steps
Operation
Key
LED Display Screen
after Operation
Description
1
Turn on
Power
When the power is turned on, Enter the
Status
Display Screen
.
2
Press MODE Key 2 times to enter
Diagnostic
Parameters
.
3
Press UP Key 8 times to select
dn-09
item.
4
Press and hold the ENTER Key for 2 seconds, enter
the Display
Software Version
Screen, the Software
Version is 2.80.
5
Press MODE Key 1 time to jump back to the
Parameter Selection Screen.
dn-11.0 (Automatic detection of magnetic angle position)
The Magnetic Angle Detection refers to detecting the electrical angle coordinates (electrical angle
phase) of the Servo Motor. If the servo system does not correctly know the servomotor's electric angle
coordinate position, the servomotor cannot be controlled normally. For the automatic alignment function
of the Encoder Magnetic Angle, the operation steps are as follows:
1. Motor U, V, W are wired in accordance with TECO Phase Sequence
2. Connect the Encoder Wiring
3. Motor No-load Condition
4. After the Driver is powered ON, set the Parameter dn-11=1, it will enter the excitation state
automatically at this time, (Display the word of "auto" during the process).
5. After the completed auto-alignment, it will leave the page automatically and dn-11 returns to 0
6. The electrical angle can be confirmed from Un-43. Motor does not move after alignment. Un-
43 should be original Un-43 electrical angle ±1°
To Next Page
Loading...
