TECO JSDG2S Series - Page 165

5-40
Parameters Description Setting range Unit
Take effect
method
Related
chapter
Pn315.0 Pulse wave error amount clear mode 0 ~ 2
--
Take effect
after setting
5-4-6
Pn315.1 Origin reset offset method setting 0 ~ 1
--
Take effect
after setting
5-4-7
Pn315.3
Electronic gear ratio takes effect
immediately flag
0 ~ 1
--
Power reset
5-4-3
Pn317.0
After the origin reset has started,
origin search direction and select
origin reference point setting
0 ~ 9
--
Take effect
after setting
5-4-7
Pn317.1
After finding the origin reference
point, setting for the moving method
to search for the mechanical origin
0 ~ 2
--
Take effect
after setting
5-4-7
Pn317.2 Origin reset start mode setting 0 ~ 2
--
Take effect
after setting
5-4-7
Pn317.3
Stop mode setting after finding the
mechanical origin
0 ~ 1
--
Take effect
after setting
5-4-7
Pn318
Origin return to first stage of high
speed
1 ~ rated rotation
speed
rpm
Take effect
after setting
5-4-7
Pn319
Origin return to the second stage of
low speed
1 ~ rated rotation
speed
rpm
Take effect
after setting
5-4-7
Pn320 Origin return to offset of lap number -30000 ~ 30000
rev
Take effect
after setting
5-4-7
Pn321
Origin return to offset of pulse
number
Varies according to
the encoder
pulse
Take effect
after setting
5-4-7
Pn329 Pulse command smooth filter 0 ~ 2500
2ms
Power reset
5-4-4
Pn330 Pulse command movement filter 0 ~ 250
0.4ms
Take effect
after setting
5-4-4
Pn332.3 Pulse response filter flag 0 ~ 1
--
Take effect
after setting
5-4-1
Pn354 Single pulse command function
Varies according to
the encoder
pulse
Power reset
5-4-3
Pn355
Operation mode of the origin reset
function
0 ~ 37
--
Take effect
after setting
5-4-7
Pn356 Pulse response filter 1 ~ 1000
Hz
Take effect
after setting
5-4-1
Note: Servo gain adjustment related parameters were not listed above; please refer to “6 Servo Gain
Adjustment” for gain adjustment related parameters