6-20
Cn063.0 Automatic Mechanical Vibration Suppression Enabling Selection
Initial Value Unit Setting Range Effective RS-485 Address
0 -- 0 ~ 5 Effective after Set 0042H
Setting Description:
Setting Description
0 Disable automatic detection of mechanical vibration frequency
1 Enable automatic detection of first set mechanical vibration frequency
2 Enable automatic detection of second set mechanical vibration frequency
3 Enable automatic detection of third set mechanical vibration frequency
4 Enable automatic detection of fourth set mechanical vibration frequency
5 Enable automatic detection of firth set mechanical vibration frequency
Cn064 Mechanical Vibration Detection Level
Initial Value Unit Setting Range Effective RS-485 Address
50 -- 1 ~ 1000 Effective after Set 0043H
Setting Description: The automatic detection level when executing automatic mechanical vibration
suppression (Cn063=1), the lower the value is, the more likely the noise is
determined incorrectly, the recommended setting is 50 or higher.
(3) Use PC-Link to search for resonance frequency and further set Notch Filter
In addition to automatic search, the PC-Link mechanical characteristic analysis can also be used
to analyze the Resonance Frequency, and manually set
Cn013
(First set notch filter frequency) the
frequency when vibration occurs, then in coordination with
Cn014
(First set notch filter quality
factor) to adjust the frequency range to be suppressed. The smaller the
Cn014
value is, the wider the
frequency range of suppression, followed in coordination with
Cn065
(First set notch filter depth) to
adjust the depth range to be suppressed, the user can adjust according to actual conditions. If there are
multi-point resonances on the platform, please adjust the second to the fifth point resonance
suppression parameters of
Cn066~Cn077
in accordance with the setting method of the first set.
Attention! When Cn013, Cn066, Cn069, Cn072, Cn075 is set to zero, indicating the notch filter
is not used.
To Next Page
Loading...
