Tektronix TB1052B-EDU - Appendix E: Default Setup; Default Setup Parameters

Appendix E: Default Setup
This appendix describes the options, buttons and controls that change settings
when you push the Default Setup button. The last page of this appendix lists
settings tha
t do not change.
NOTE. When you push the Default Setup button, the oscilloscope displays the
channel 1 waveform and removes all other waveforms.
Menu or system Option, button, or knob Default setting
(three mode options) Sample
Averages 16
Acquire
Run/Stop
Run
Autoran
ge
Off
Autoran
ge
Mode Vertic
al and Horizontal
Type
Off
Cursor
Sourc
e
Ch1
Type Vectors
Persist
Off
Format YT
Display
Back
light
60%
Source Ch1
Wi
ndow
Ha
nning
FFT
FFT Zoom X1
Position 0.00 sHorizontal
Scale (seconds/division)
5
00 μs
Operation
-
Sources Ch1 - Ch2
Position 0 divs
M
ath
Vertical Scale
2V
Source Ch1Measure (all)
Type None
Type Edge
Source Ch1
Slope
Rising
Mode Auto
Coupling DC
Trigger
Holdoff
500.0 ns
TBS1000B and TBS1000B-EDU Series Oscilloscopes User Manual 127