USB Flash Drive a nd Device Ports
4. Run your GPIB so
ftware on your GPIB system.
5. If the oscilloscope and your GPIB system do not communicate, refer to the
information o
n the software for your GPIB system, and to the user manual for
the TEK-USB-488 adapter to resolve the problem.
Command Entry
NOTE. For command information, refer to the TBS1000B, TDS2000C and
TPS2000 Series Digital Oscilloscopes Programmer Manual, 077-0444-XX. You
can downlo
ad manuals at www.tektronix.com/manuals.
68 TBS1000B and TBS1000B-EDU Series Oscilloscopes User Manual
To Next Page
Loading...
