Compliance information
United Kingdom
1
This product is intended for use in nonresidential areas only. Use in residential areas may cause electromagnetic
interference
.
2
Emissions which exceed the levels required by this standard may occur when this equipment is connected to a
test object.
3
To ensure compliance with the EMC standards listed here, high quality shielded interface cables should be used.
4
The instrument will exhibit ≤ 3.0 division waveform displacement and ≤
6.0 division increase in peak-to-peak noise when subjected to radiated
interference
per IEC 61000-4-3.
5
The instrument will exhibit ≤ 2.0 division waveform displacement and ≤
4.0 division
increase in peak-to-peak noise when subjected to conducted
interference per IEC 61000-4-6.
6
Performance
Criterion C applied at the 70%/25 cycle Voltage-Dip and the 0%/250 cycle Voltage-Interruption test
levels (IEC 61000-4-11). If the instrument p owers down upon a voltage dip or interruption, it will take longer than
ten seconds to return to the previous operating state.
Australia / New Zealand
Declaration of
Conformity – EMC
Complies wi
th the EMC provision of the Radiocommunications Act per the:
CISPR 11:2003. Radiated and Conducted Emissions, Group 1, Class A, in
accordanc
e w ith EN 61326-1:2006 and EN 61326-2-1:2006.
Australia / New Zealand contact.
Baker & McKenzie
Level 27, AMP Centre
50 Bridge Street
Sydney NSW 2000, Australia
FCC–EMC
Exempt from FCC 47 CFR, Part 15.
Russian Federation
This p
roduct is approved by the Russian government to carry the GOST mark.
x TBS1000B and TBS1000B-EDU Series Oscilloscopes User Manual
To Next Page
Loading...
