Telephone Line Emulator User’s Manual
40-400-00020, Rev. M 96
Netherlands Defaults
These items will be preset in configuration #9. Refer to the TLE-INTL section for more
details.
Dial Tone, Busy Tone, Reorder Tone, Ringing Tone, Ringing, SIT or Number
Unobtainable, Call Waiting Tone (Subscriber alerting signal, SAS),
Call Waiting Type: Normal (single) SAS tone, no CID will follow
Caller ID Mode (Ringing)
DTMF format, sent after initial line reversal,
then back to previous polarity at start of ring.
Dial Prefix for Private ∗67 (Using Bellcore default, have not
identified a specific prefix for the
Netherlands)
Dial Prefix for OTA ∗87
Calling Number 10 Digit Limit Disable
Prefix Number Line 1 0;”interlocal” access code
Prefix Number Line 2 0
Prefix Number Line 3 0
Prefix Number Line 4 0
DTMF row & column levels Row = –12 dBm
Column = -10 dBm
DTMF transmission type Calling Number Only
DTMF On/Off time 70 mS
Timers:
DTMF/FSK end to ring start 200 mS
Line reversal to DTMF 300 mS
Ring Cadence Group 1 1 sec on/4 sec off
Ring Cadence Group 2 .8 sec on/.4 sec off/.8 sec on/ 4 sec off
Ring Cadence Group 3 1 sec on/1 sec off/1 sec on/ 3 sec off
To Next Page
Loading...