Teltone TLE-A - Phone Number Prefix and Group Selections; Network Message Status; Extension for Network Operator; User Defined Parameters

Telephone Line Emulator User’s Manual
40-400-00020, Rev. M
81
Network Message Status
Programmable as one of the following:
00H – no messages
01H – 1 or unspecified number of messages
02H to FFH – number of messages waiting
Extension for Network Operator
Defined as follows:
1
st
digit of country code (per ITU Q.11)
2
nd
digit of country code or space if no 2
nd
digit
3
rd
digit of country code or space if no 3
rd
digit
Network Operator code (alphanumeric characters)
Version code (alphanumeric characters)
User Defined Parameters
Up to 3 User Defined single byte parameters may be defined. These are to provide for the
future addition of parameter types currently reserved. For each parameter the user must
provide a parameter Type byte and a parameter Value byte.
Acknowledge - CIDCW
The TLE monitors for a DTMF “D” as an ACKnowledge digit. This is the Bellcore specified
digit expected from a non-ADSI device. The TLE will also monitor for an alternate DTMF
ACKnowledge digit, which is programmable. The default value is a DTMF “A”, which
corresponds to the Bellcore specified digit expected from an ADSI device. The ETSI
requirements state that a DTMF “D” must be accepted as a valid ACKnowledge digit, but
that “A”, “B”, and “C” may be considered valid digits in some networks.
Phone Number Prefix and Group Selections
Figure 38. Caller ID/Call Waiting - Phone Number Prefix and Group Selections