Telephone Line Emulator User’s Manual
40-400-00020, Rev. M
101
US/Canada Defaults
These items will be preset in configuration #9. Refer to the TLE-INTL section for more
details.
Dial Tone, Busy Tone, Reorder Tone, Ringing Tone, Ringing, SIT or Number
Unobtainable, Call Waiting Tone (Subscriber alerting signal, SAS)
Reference Standard: Bellcore GR-30-CORE, TR-NWT-000031,
TR-NG-001188, TR-NWT-001401
Call Waiting Type: Normal (single) SAS tone, followed by CAS
and CID if ACK seen
Line Impedance: 900 ohms
CAS low tone: 2130 Hz @ -15 dBm
CAS high tone: 2750 Hz @ -15 dBm
CAS duration: 80 mS
CAS wait for acknowledge 160 mS
CAS alternate acknowledge digit DTMF A
FSK frequency
Low tone (MARK) 1200 Hz
High tone (SPACE) 2200 Hz
Level -15 dBm
Caller ID Mode (Ringing)
Multiple Message Format; send after first pause in ring cycle
Normal CID Table Parameters (up to 9 maximum)
Date/Time
Calling Line Identity
Calling Party Name
Private CID Table Parameters (up to 6 maximum)
Date/Time
Calling Line Identity Private
Out of Area (OTA) CID Table Parameters (up to 6 maximum)
Date/Time
Calling Line Identity Unavailable
Dial Prefix for Private *67
Dial Prefix for Out of Area (OTA) *87
Calling Number 10 Digit Limit Enabled
Message Type for CID not associated with ringing
Message Waiting Indicator
Mode for CID not associated with ringing
Single Message Format, sent after OSI
Parameters for CID not associated with ringing (up to 6 maximum)
Visual Indicator On
To Next Page
Loading...