Telephone Line Emulator User’s Manual
40-400-00020, Rev. M 98
Sweden Defaults
These items will be preset in configuration #9. Refer to the TLE-INTL section for more
details.
Dial Tone, Busy Tone, Reorder Tone, Ringing Tone, Ringing, SIT or Number
Unobtainable, Call Waiting Tone (Subscriber alerting signal, SAS)
DTMF row level -12 dBm
DTMF column level -10 dBm
DTMF on/off time 70 mS
DTMF transmission type Calling Number Only
Line Impedance: 270 ohms + ( 750 ohms || 150 nanofarads)
Call Waiting Type: Normal (single) SAS tone, no CID will follow
Caller ID Mode (Ringing) DTMF format, sent after initial line reversal
then back to previous polarity at start of ring.
Dial Prefix for Private ∗67 “Calling Party is Restricted”
Dial Prefix for OTA ∗87 “Calling Party is Not Available”
Calling Number 10 Digit Limit Disabled
Prefix Number Line 1 clear
Prefix Number Line 2 clear
Prefix Number Line 3 clear
Prefix Number Line 4 clear
Timers
DTMF/FSK end to ring start 200 mS
Line reversal to DTMF 200 mS
Ring Cadence Group 1 1 sec on/5 sec off
Ring Cadence Group 2 .8 sec on/.4 sec off/.8 sec on/ 4 sec off
Ring Cadence Group 3 1 sec on/1 sec off/1 sec on/ 3 sec off
To Next Page
Loading...