Telephone Line Emulator User’s Manual
40-400-00020, Rev. M 114
Error Message: Port Timeout Error. Please check that the TLE is properly connected to
your PC and powered up.
Explanation: Communications to the TLE have failed. Verify the TLE is still connected
to the port, and has power.
Error Message: TLE not responding. Retry?
Explanation: A communications error has occurred while sending data to the TLE.
Retrying will attempt to resend the data to the TLE.
File Errors
Error Message: File “filename” is not compatible with the TLE that is currently
connected.
Explanation: The file being opened contains a configuration set for a TLE with
upgraded features for which the current TLE has not had the upgrade
installed.
Error Message: File “filename” is not a TLE Configuration Set file.
Explanation: The file being opened is not a TLE configuration file.
Error Message: Error occurred during download.
Explanation: An error occurred while downloading a microcontroller or DSP code file,
or a voice message. The user should re-attempt the download.
Error Message: TLE must be idle before starting download. Go on-hook with all phones
and retry.
Explanation: The TLE does not support calls while downloading microcontroller or
DSP code files, or voice messages. The user should go on-hook on all
phones connected to the TLE and wait for all lines to be idle (display
shows “On hook” for all lines) and then re-attempt the download.
Error Message: File “filename” not found! (Audio File)
Explanation: See Audio Related Error Messages.
Error Message: Wrong File Type! File must be Mono 8.000kHz 8-bit mu-law wave file.
Explanation: See Audio Related Error Messages.
Telephone Wiring Variants
The wiring for the RJ-11 connections is based upon Bellcore standards with the signaling
on pins 3 and 4 of the 6 pin modular connector. Some countries, such as the U.K., need
special wiring to operate correctly.
To Next Page
Loading...