Teltone TLE-A - Australia Defaults

Telephone Line Emulator User’s Manual
40-400-00020, Rev. M 90
Australia Defaults
These items will be preset in configuration #9. Refer to the TLE-INTL section for more
details.
Dial Tone, Busy Tone, Reorder Tone, Ringing Tone, Ringing, SIT or Number
Unobtainable, Call Waiting Tone (Subscriber alerting signal, SAS)
Reference Standard: ACA TS 002
Call Waiting Type: Normal (single) SAS tone, followed by CAS
and CID if ACK seen
Line Impedance: 220 ohms + (820 ohms || 120 nF)
CAS low tone: 2130 Hz @ -26 dBm (6 dB above min detect
level for CPE)
CAS high tone: 2750 Hz @ -26 dBm
CAS duration: 80 mS
CAS wait for acknowledge 160 mS
CAS alternate acknowledge digit DTMF A
FSK frequency
Low tone (MARK) 1200 Hz
High tone (SPACE) 2200 Hz
Level -28 dBm ( 6 dB above min detect level for
CPE)
Caller ID Mode (Ringing)
Multiple Message Format; send after ring burst alerting signal; normal ringing
follows
Normal CID Table Parameters (up to 9 maximum)
Date/Time
Calling Line Identity
Calling Party Name
Private CID Table Parameters (up to 6 maximum)
Date/Time
Calling Party Name Private
Out of Area (OTA) CID Table Parameters (up to 6 maximum)
Date/Time
Calling Party Name Unavailable
Dial Prefix for Private ∗67
Dial Prefix for Out of Area (OTA) ∗87
Calling Number 10 Digit Limit Disabled
Prefix Number Line 1 15551
Prefix Number Line 2 15552
Prefix Number Line 3 15553
Prefix Number Line 4 15554
Message Type for CID not associated with ringing
Message Waiting Indicator
Mode for CID not associated with ringing
Multiple Message Format, sent after OSI
OSI time = 0, disabled
Parameters for CID not associated with ringing (up to 6 maximum)
Visual Indicator On