Telephone Line Emulator User’s Manual
40-400-00020, Rev. M 40
References
Teltone has used the following references for each of the countries specified,
however, you may find that certain parameters may be different for any
specific country. It is up to the user to verify that operating parameters are
valid for their application and usage.
[1] TR-TSY-000064 LSSGR Issue 2, Section 6, (Signaling)
[2] TR-NPL-000275 BOC Notes on the LEC Networks (BNLN),
Issue 2, April 1994
[3] GR-30-CORE, Bellcore Publication, LSSGR: Voiceband Data Transmission
Interface, Section 6.6, Issue 1, 12/94
[4] ITU Fascicle II.2, Recommendation E.180, Supplement #2, 1/94, Telephone
Network and ISDN - Operation, Numbering, Routing, and Mobile Services - Various Tones
Used in National Networks
[5] ETSI, European Telecommunications Standard, (ETS300-001), Attachments to
the Public Switched Telephone Network; General technical requirements for equipment
connected to an analogue interface in the PSTN (Candidate NET 4), March 1992.
[6] British Standard BS 6305: 1992, General requirements for apparatus for
connection to the public switched telephone network run by certain public
telecommunications operators.
[7] Swedish Specification TVT 8211-A 112E, Technical requirements for connection
of subscriber equipment to the public switched telephone network.
[8] Singapore TAS TS PSTN 1, Issue 3 Rev 4, 1 April 1997, Approval Specification
for terminal equipment for connection to Public Switched Telephone Network & Analogue
Leased Circuits.
[9] Japan Approvals Institute for Telecommunications Equipment web site:
(accessed 9/29/97) http://www.sphere.ad.jp/jate/english. Overview of Technical
Conditions, Conditions specific to Analog Telephone Terminals. Ordinance Concerning
Terminal Facilities, Terminal Facilities to be Connected to Telephone Circuit Facilities.
Reset to Defaults
Note: When the front panel Reset button is pressed, the unit will be reset to the US/Canada
defaults for all 16 configurations (country codes). The user must perform “Defaults” and
“Send All” from the PC configuration software to reload the defaults for each individual
country.
To Next Page
Loading...