Teltone TLE-A - Caller ID Configuration and Timing

Telephone Line Emulator User’s Manual
40-400-00020, Rev. M 72
Caller ID Configuration
This is a per-line programmable parameter.
Off, Caller ID in Call Waiting will also be disabled
Single Data Message Format
Multiple Data Message Format
Bellcore
Bellcore Plus
ETSI DTMF
ETSI FSK
Date and Time
The date and time is sent by the TLE as Month, Day, Hour, and Minute.
Normal Caller ID
The Normal Caller ID transmission can be programmed for up to 9 parameter types. The
Caller ID in Call Waiting format selection is the same as the Normal CID parameters, if
enabled.
Out of Area
The Out of Area transmission can be programmed for up to 6 parameter types. An Out of
Area message can be issued by dialing a special prefix before the telephone number.
The dialing prefix is programmable, up to 4 digits in length. The default is 87.
Private
A Private transmission can be programmed for up to 6 parameter types. A Private
message can be issued by dialing a special prefix before the telephone number. The
dialing prefix is programmable, up to 4 digits in length. The default is 67.
Checksum
The Checksum is a block of data used to detect an error in the Caller ID message. An
artificial error can be introduced in the TLE by dialing a special prefix (88) before the
telephone number. The TLE will transmit the same data block as a Normal transmission,
but it will deliberately send an invalid checksum. Different products will display different
messages, and some times no message, when this error occurs.