Telephone Line Emulator User’s Manual
40-400-00020, Rev. M
75
The following Caller ID Standards may be selected:
Bellcore
Bellcore Plus
ETSI DTMF
ETSI FSK
Everything
The standard(s) selected affect the options programmed on subsequent screens.
Selection of multiple standards or Everything requires the user to choose only
those options appropriate to the Caller ID Standard for the line selected.
Caller ID
Options available are:
Enable/Disable Caller ID
Select the Caller ID message format:
SDMF (Single Data Message Format)
MDMF (Multiple Data Message Format)
DTMF
Select the Alerting Sequence:
Dual Tone
None
Pause in Ring Cycle
Reversal
Reversal (restores at Ring)
Reversal + Dual Tone
Ring Burst
Note: Not all Alerting Sequences are available for all Caller ID message formats.
No Ringing CID
No Ringing CID (or Caller ID not associated with ringing), is also commonly known as
Message Waiting.
Options available are:
Select the message format:
SDMF (Single Data Message Format)
MDMF (Multiple Data Message Format)
Select the Alerting Sequence:
Open Switch Interval (OSI)
Ring Burst
Dual Tone
Reversal + Dual Tone
Note: Not all Alerting Sequences are available for all message formats.
To Next Page
Loading...