Tenda i9 - Page 63

56
--End
Parameter description
Parameter
Description
Enable RF
It specifies whether to enable the RF function of the AP.
Country
It specifies the country or region where the AP is used. This parameter helps comply
with channel regulations of the country or region.
Network Mode
It specifies the wireless network mode of the AP.
Available options include 11b/g, 11b, 11g, and 11b/g/n. This parameter can be set if
Lock Channel is not selected.

11b: It indicates that only clients working in the 11b network mode can connect to
the AP.

11g: It indicates that only clients working in the 11g network mode can connect to
the AP.

11b/g: It indicates that only clients working in the 11b or 11g network mode can
connect to the AP.

11b/g/n: It indicates that clients working in the 11b, 11g, or 11n network mode can
connect to the AP.
Channel
It specifies the operating channel of the AP. This parameter can be set if Channel
Lockout is not selected.
Channel Bandwidth
It specifies the bandwidth of the operating channel of the AP. This parameter can be
set if Channel Lockout is not selected.

20MHz: It indicates that the AP only uses 20 MHz channel bandwidth.

40MHz: It indicates that the AP only uses 40 MHz channel bandwidth.

20/40MHz: It indicates that the AP automatically adjusts its channel bandwidth to 20