Tenda i9 - Logs; View Logs

74
8.2 Configuring the SNMP function
Step 1 Choose SNMP and set SNMP Agent to Enable.
Step 2 Set related SNMP parameters.
Step 3 Click Save.
--End
Parameter description
Parameter
Description
SNMP Agent
It specifies whether to enable the SNMP agent function of the AP. By default, it is
disabled.
An SNMP manager and the SNMP agent can communicate with each other only if
their SNMP versions are the same. Currently, the SNMP agent function of the AP
supports SNMP V1 and SNMP V2C.
Administrator
It specifies the name of the administrator of the AP. The default name is
Administrator. You can change the location as required.
AP Name
It specifies the name of the AP. The default device name is in the format of Model
+ Hardware version number.
It is recommended that you change the AP name so that you can easily
identify the AP when managing the AP using SNMP.
Location
It specifies the location where the AP is used. You can change the location as
required.
Read Community
It specifies the read password shared between SNMP managers and this SNMP
agent. The default password is public.
The SNMP agent function of the AP allows an SNMP manager to use the password
to read variables in the MIB of the AP.
Read/Write Community
It specifies the read/write password shared between SNMP managers and this
SNMP agent. The default password is private.
The SNMP agent function of the AP allows an SNMP manager to use the password
to read/write variables in the MIB of the AP.