Texecom Premier Elite 24

P Premier Elite 24,24-W, 48,48-W, 88, 168 & 640 Installation Manual Area Programming
INS176-9 57
Suite Arm Modes
E o elec:-
ea ogaing
ea ogaing
ie  odes
ea ogaing
ies
ie   y:
ied ei
ie   y:
 Eny/Ei
ie   y:
ied ei
Use keys 1 - 5 to select
an a rming mode
e.g. 1 = Entry/Exit
Use the SCR OLL key
to s ele ct a suite
y
4
y

1
y
The way that an Area Arm Suite arms when selected, can be
configured for any of the following options:
1 - Entry/Exit
The suite will arm after the ‘Entry/Exit’ door has been closed and the
‘Exit Settle’ timer has expired.
2 - Exit Term.
The suite will arm after the ‘Entry/Exit’ door has been closed, the ‘Exit
Terminator’ button has been pressed and the ‘Exit Settle’ timer has
expired.
3 - Timed Exit (Default for All Areas)
The suite will arm after the programmed ‘Exit Time’ has expired.

If an ‘Exit Terminator’ zone is activated at any point during the
exit mode, any remaining exit time is cancelled and the area
will arm immediately.
4 - Instant
The suite will arm instantly.
5 - Deferred
The suite will arm after the programmed ‘Exit Time’ has expired.
However, if any zones not on the exit route are activated during the
exit mode, the ‘Exit Time’ is restarted.
Area Options 24/48/88/168
E o elec:-
ea ogaing
ea ogaing
ea pions
ea ogaing
ies
o a 

Use keys 1 - 8
to s ele ct a n a rea
e.g. 4 = D
U s e th e S C R O L L
ke y to select an
area option
eoe 

Press NO to cha nge
the area option
eoe 
  <
eoe 
  <
y
5
y

n
4
y
Area Options 640
E o elec:-
ea ogaing
ea ogaing
ea pions
ea ogaing
ies
o a  

o a  

o a  
<
o a  

y
5
y

n
4
y
Us e the S c roll Ke y to s ele ct
the option.
Use the Area ke y to select
th e A r m A r e a 1 - 4
Pre s s N O to ed i t
the option
Use the C hime & Part keys
to select the Arm Area .
Us e the Ar ea ke y to toggle
between A reas A to H
and I to P. Us e the 1-8 keys to
toggle the Areas on & off