Texecom Premier Elite 24

UDL & Digi Options Premier Elite 24,24-W, 48,48-W, 88, 168 & 640 Installation Manual
88 INS176-9
Digi Options
E o elec:-
U/igi pions
U/igi pions
ese igi
igi pions
     
Press NO to edit
the Dig i o ptio n
igi is Enaled
     
lind ialling
    
U/igi pions
igi pions
Use keys 1 - 8 to se lec t
an option or use the
SC R OLL key to search
lind ialling
    
Press NO to
select/deselect
the option
y
4
y
n

n
y
There are 6 options that control how the plug-on communicator
works.
Select options by pressing keys 1 to 8 (a letter on the display means
the option is selected, a Dot on the display means the option is not
selected).
E - Digi is Enabled
The plug-on communicator will report all system events to the Alarm
Receiving Centre.
P - Pulse Dialling
The plug-on communicator will always dial telephone numbers using
pulse dialling.
3 - Pulse After 3
The plug-on communicator will always dial telephone numbers using
tone dialling. However, if the Communicator fails to dial the number
three times in a row, it will revert to pulse dialling for the remaining
attempts.
B - Blind Dialling
The plug-on communicator will not look for a dial tone before dialling
a telephone number.
U - Use MSN/Pre-Dial
The ComISDN will only answer a call when the programmed
MSN/Pre-Dial telephone number is dialled.
A - Dial All Numbers
If the communicator is acknowledged by the first ARC, it will continue
to dial any other programmed ARC. This is normally used when a
second or third ARC is programmed with SMS Messaging.
Area Accounts 24/48/88/168
E o elec:-
U/igi pions
U/igi pions
ese igi
ea  ccon:
------
Pre s s NO to ed i t
the acc ount number
U/igi pions
ea ccons
ea  ccon:
------
^ 3
Us e k eys 0 - 9 to e nter
the acc ount number
e.g. 1234 = Account 1234
ea  ccon:
--34
Us e keys 1 - 8 to se le ct a n
area or use the S C RO LL k ey
to s ea rch e. g. 2 = Area B .
y
6
y
2
n

y
When using Fast Format, Contact ID or SIA, each area can have its
own account number to identify events.
Account Numbers A to H (I to P)
This is the account number that will be reported to the Alarm
Receiving Centre. Each account number can be up to 6 digits.

In order for the control panel to use the area account numbers,
the area account Config. option must be enabled (see page 87
for details).