EX-TRACK
®
Operator Manual, Revision T-112
1.1. General system safety precautions
1.1.1. System safety
The EX-TRACK
®
CNC System is fitted with an Emergency Stop or E-Stop Button. This button is used
to isolate the system from the input (120V/220V) power source. It is intended for use in the case
of an accident or emergency. The E-Stop Button is clearly located on the top of the Main Unit, to
operate, press in to isolate the power to the CNC and drive mechanisms, none of the systems
functions can operate. To restore power to the system, lift the E-Stop Button upwards, the screen will
illuminate and all of the systems functions are restored.
1. The system casing is made from cast Aluminium and sheet metal, exercise care when
handling, do not let the system drop from any height, and protect the system from falling
objects.
2. Oxygen and fuel gas fittings and connections should be tightened using a suitable wrench,
perform a leak test and retighten as required.
3. When fixing a nozzle to the oxy fuel torch, tighten the nut with two wrenches. In addition,
avoid; damaging the seat of the nozzle since this may cause flashback.
4. Never disassemble the system other than during maintenance and inspection. Otherwise,
a system malfunction may occur.
5. Never modify the system. Modification can be very dangerous and voids the warranty.
6. Switch the power off when the system is not in use.
7. Never use the system outside in the rain, the system may malfunction, this could result
in serious injury or death.
8. This system is not intended for use with plasma cutting power supplies that utilize high-
frequency (H/F) arc ignition.
1.1.2. Personal protective equipment
1. During operation, ensure that suitable personal protective equipment is used: gloves,
gauntlets, goggles, face shields, safety shoes, and additional equipment as required.
2. Prohibit operation of the system if clothes or hands are wet, in order to prevent electric shock,
electric shock can cause serious injury or death.
To Next Page
Loading...