THERMACUT EX-TRACK - Delete Files [F4]; Delete Line [F5]; Process Definition - Speed; Save [F3]

EX-TRACK
®
Operator Manual, Revision T-166
9.7.1.3. Save [F3]
Edited programs can be saved in the memory, they can be renamed using the keypad, a maximum
of 12 characters can be used to name a file. Press [ENTER] to save changes and [ESC] to leave
without change.
9.7.1.4. Delete files [F4]
Press [F4], for an on-screen list of files stored in the systems memory, to remove a file press the
[ENTER] key.
9.7.1.5. Delete line [F5]
Press [F5] to delete a line of input within a program.
9.7.1.6. USB [F6]
Using a USB memory stick, program files can be uploaded to the program editor function, press
[F1] to display the available programs. Press [ENTER] to download the file into the Editor. Run the
program in the Auto Mode, press [F3] to name and store in the systems memory. The USB memory
stick can be used to upload programs for storage or transfer in the OUTPUT mode, press [F2} to
store the data.
9.7.1.7. View [F7]
Lets the operator see an on-screen image of the program, accessed through the LOAD function in
the program memory or USB stick.
9.8. Setup [F4 PARAMER]
9.8.1. Process definition - speed
For adjustment to all speed related settings. SYST: process/tolerance adjustment and control,
software upper/lower limits. OXY: parameter settings for oxy fuel preheat and cutting. PLASMA:
parameter settings for plasma pierce/cutting and Arc Voltage Control. CONTROL: process control
options e.g. Plasma-Flame/Inch-Metric. The actual list of parameters exceeds what is displayed
on the first screen, scroll to reveal more, using the keypad, input new values. Press the [F7] key to
accept the changes, if they are not saved prior to pressing the [ESC] key, they will be deleted.