THERMACUT EX-TRACK - Basic Trouble Shooting

EX-TRACK
®
Operator Manual, Revision T-1 85
10.2. Basic trouble shooting
Fault This may
mean
Cause Solution
System won’t
move.
• Drive Power
Indicator Lamp is
ON - illuminating.
• Off Line pushbutton
may be pressed.
• Press Off Line pushbutton
until it pops out.
• Main power switch
is OFF.
• Make sure, that main power
switch is turned ON.
Torch lifter
won’t move up
or down.
• Up and Down
relays on CNC
are activating.
• Cable un-plugged
or damaged.
• Check plugs and cables at
both ends of Transverse rail.
Check plug on Connector
Panel on rear of Main Unit.
Inspect cable for damage.
• Lift Motor or Micro
Switch Failed.
• Check for 24 VDC at motor
cable plug. Replace fuse,
motor or Micro Switches if
necessary.
• Up and Down
relays are not
activating.
• 24 Volt Power may
be missing.
• Check output of 24 Volt
Power Supply. Check 24
Volt fuse on left side panel.
Replace if necessary.
• Check connections to side of
CNC unit.
WARNING!
HIGH VOLTAGE is present inside this system, ONLY suitably
qualified personnel should remove the cover for the purpose of
Service or Repair. ELECTRIC SHOCK CAN KILL!