EX-TRACK
®
Operator Manual, Revision T-184
Q: Why does the system lock-up when reading the USB stick?
A: If the USB stick checks out OK, there may be two reasons:
1. There may be system or hidden files on the USB stick that the CNC is attempting to read. Some
system files will cause the CNC to repeatedly attempt to read a file which cannot be understood by
the CNC, so it appears to be locked up. It is suggested that the USB stick be freshly re-formatted,
and only the necessary part programs be stored on it.
2. Inspect the USB socket to see if it may be loose, or if it may have become fouled with dirt or soot.
USB must be formatted according to original instructions. This CNC only supports FAT or FAT32 file
systems. Format to FAT or FAT32.
To Next Page
Loading...
