EX-TRACK
®
Operator Manual, Revision T-1 17
ATTENTION: Prior to starting the cutting process, perform a system/equipment check to ensure
there are no gas leaks or visible damage to component parts. If during the cutting process there is
the odor from a gas leak, immediately press the E-Stop button to isolate the electrical power supply,
turn off the gas supply at the torch and then at the point of supply - Cylinder/Manifold. Do not use
the system until it has been checked and deemed safe to use by a suitably qualified person. You are
responsible for your own safety as well as others.
To Next Page
Loading...
