EX-TRACK
®
Operator Manual, Revision T-1 31
Plug the torch height motor control lead in to the corresponding input on the main unit side panel.
Ensure that there is a functional ground terminal on the input power lead. If not grounded, the
operator is at risk of an electrical shock.
Grounding (earthing) the system
The Power lead of this system is equipped with a grounding wire (earth), it is to be plugged in to
a mains/network socket that is equipped with a mating ground (earth) terminal, connection and
supply are to be in accordance with local electrical codes and regulations.
Stop operation and cut off the power in the following cases, inform a suitably qualified
person, do not use the system until it is fully repaired/functional.
• Brokenorabradedcables.
• Waterhasenteredthemaincontrolunit.
• AllsettingsareInaccordancewiththeoperatingmanual,butthesystemrunserratically.
• Thesystemstopsfunctioning.
To Next Page
Loading...
