THERMACUT EX-TRACK - Page 6

EX-TRACK
®
Operator Manual, Revision T-16
9.7.1.5. Delete line [F5] .............................................................................................. 66
9.7.1.6. USB [F6] .......................................................................................................... 66
9.7.1.7. View [F7] ......................................................................................................... 66
9.8. Setup [F4 PARAMER] .......................................................................................... 66
9.8.1. Process definition - speed ............................................................................... 66
9.8.2. Speed parameters [F1] .................................................................................... 67
9.8.3. System parameters .......................................................................................... 68
9.8.4. OXY parameters ............................................................................................... 69
9.9. Plasma parameters .............................................................................................. 70
9.9.1. Control parameters ......................................................................................... 71
9.9.2. THC .................................................................................................................... 73
9.9.3. Save [F7] ............................................................................................................ 74
9.9.4. Gallery function ................................................................................................ 74
9.9.5. Graphics library ................................................................................................ 74
9.9.6. Graphics library (shape development) .......................................................... 75
9.9.7. Shape check ...................................................................................................... 75
9.9.7.1. Inside diameter cut [F1] and [F2] Outside diameter cut .......................... 75
9.9.8. Graphics library (nest function) ...................................................................... 76
9.10. Program function ............................................................................................... 76
9.10.1. CNC program symbols (G - codes).............................................................. 76
9.10.2. File types ......................................................................................................... 77
9.10.3. File names ....................................................................................................... 77
9.10.4. Units of measurement ................................................................................... 77
9.10.5. Programming ................................................................................................. 77
9.10.6. System axes .................................................................................................... 77
9.10.7. G-codes .......................................................................................................... 78
9.10.8. G92 – program zero point ............................................................................. 78
9.10.9. G90 – absolute commands ........................................................................... 78
9.10.10. G91 – incremental commands .................................................................. 78
9.10.11. G20 – imperial mode .................................................................................. 78
9.10.12. G21 – metric mode ...................................................................................... 78
9.10.13. G00 – rapid travel ......................................................................................... 79
9.10.14. G01 – linear interpolation (motion in a straight line) .............................. 79
9.10.15. G02- G03 – circular interpolation (motion along a circular arc) ............. 79
9.10.16. G04 – pause/dwell ....................................................................................... 79
9.10.17. G40 – kerf off (compensation factor) ......................................................... 79
9.10.18. G41 – kerf left ............................................................................................... 80
9.10.19. G42 – kerf right ............................................................................................. 80
9.10.20. G28 – return to reference point (zero position) ........................................ 80
9.10.21. G22 / G80 – cycle command (loop function) ........................................... 80
9.11. M - codes ............................................................................................................ 80
9.11.1. M00 - stop ....................................................................................................... 80
9.11.2. M02 – program end ...................................................................................... 80