THERMACUT EX-TRACK - Page 72

EX-TRACK
®
Operator Manual, Revision T-172
*METRIC:0 / INCH:1 : the system can be operated using Metric “0” or Inch “1” values, the system
displays length/speed in the chosen value. The (G20)/mm (G21)/inch input code can be used to run
programs in different formats.
*CALCULATION PRECISION: the default value is 0.1mm. Consider decreasing this value to minimize
the rounding up effect in the nesting program.
*CTRL OUTSIDE: function not used with EX-TRACK
®
CNC SYSTEM.
*WIRED/WIRELESS CTRL: function not used with EX-TRACK
®
CNC SYSTEM.
*G41 /G42 CHECK EFF (0/1): check for kerf faults. No/0 ; Yes/1.
*INITIAL CLEAR DOOR: program coordinates are automatically reset to zero when a program starts.
*SELECT CYLINDER UP/DOWN: function not used with EX-TRACK® CNC SYSTEM.
*SELECT AUTO-REFERENCE: torch can be automatically repositioned to the program zero point
when the program ends. NO-”0” YES-”1”.
*LIMIT POSI EFFECT: activate position limits NO-”0” YES-”1”.
*SOFTWARE LIMITS EF: activate software limits NO-”0” YES-”1”.
*CRASH DETECT: system/torch crash detection NO-”0” YES-”1”.
*CRASH DETECT NC:0 / NO:1: for plasma systems that use torch tip contact for Crash and IHS
sensing.
*CRASH PAUSE/TORCHUP: system pauses/torch lifts on crash detection.
* TORCH UP ON PAUSE: torch lifts when program is paused.
*CUTTING LINE: distance between bridge/tab points.