3
Learning Center
Basic Instrument Operations
216 NanoDrop One User Guide Thermo Scientific
Sample Name
Tap the Sample Name field in any measurement screen to edit the sample name.
When Auto-Naming is On (see General Settings), each sample is automatically assigned a
sample name using the default base name followed by a unique number starting with “1.” The
first time this appears is after the first blank measurement and before the first sample
measurement in each experiment as shown below.
In this example, the first sample would be named “Sample 1” followed by “Sample 2,” etc.
You can edit the default base name and overwrite any sample name.
Edit default sample base name
After you measure a blank and before the first sample is measured:
–tap Sample Name field to display keyboard
– enter new base name
–tap Done key
Edit sample name
– from Home screen, tap to open Data Viewer
– select experiment
– swipe left to show data table
– press and hold sample name to show Sample Details box
–tap Sample Name field to display keyboard
Note If you edit the sample base name during an experiment when Auto-Naming is
selected, the assigned sample ID numbers restart.
Default sample name; tap to edit
To Next Page
Loading...
