Topcon X-63 - Page 11

Introduction
3DExcavatorIndicateSystems
3
X‐63/X‐63i/X‐62/X‐33/X‐32InstallationandCalibrationManual P/N:7010‐0697
Sittinginthecabfacingforward,thesensoranglesare0°straightahead(horizonta l),+90°straightup,and
‐90°directlydown(Figure3).
Figure3:AngleConventionUsedForTiltSensors
TheMainandAuxiliaryantennasprovidepositionalandheadinginformation.
• Mainantenna–determines3Dmachineposition.
• Auxantenna–determinesheadingusingrelativeposition.
UsingtheTS‐1orTS‐i3sensors,the3DpositionofthebucketisprojectedfromtheMainantenna.
Figure4:TiltSensorPositionalandHeadingReferences
0
+90
-90
Main Ant
Position
Aux Ant
provides
heading
Project position from
Main Ant to bucket teeth