Firmware Version 3/4.31.37
Updated software ID to be different for PXA255 vs Atmel builds to prevent upload
image swap.
Added start of hardware watchdog timer at startup.
Updated software major number for new platform builds.
Disabled much of the email WIP code.
9/17/10 WJP
Added ability to accept analog flow meter inputs.
Added signed_div1000 and meter_input_type to configuration parameter types.
Changed "Pulse in Mass" meter configuration parameter to "Meter Type".
Added several "Analog Meter Input" parameters for @4mA Rate, @20mA Rate, Rate
Offset, and Cutoff Rate.
When Meter Type is Volume Analog Input, ports 4 and 5 can be used for other
functions.
Updated meter diagnostic screen to display Input mA.
Corrected Mandarin LOW FLOW and HIGH FLOW text.
Increased latest known FCM version to 039.
Added R/U998 to read/update bitmap cache data area (16MB 0x00000000-0x00ffffff).
Added T`hrcwhoooooooo command to display graphics from the cached bitmap data
area.
Changed firmware version to 3.29.21.
Changed equipment database version to 3.29.21.
10/7/10 WJP
Added a blue screen exception handler that will display the type of fault,
address of fault and all register values.
12/9/10 3/4.30.00 WJP
Switched to eCos RTOS for Atmel processor (same OS as xScale uses).
Removed all references to IAR and Keil compilers and RTOS.
Added Atmel Exception Handler Blue Screen.
Added CN GPS tracking demo code.
Added 200 gps position log.
Added compiler switches for GPS_SITE_DATABASE and GPS_POSITION_LOG.
Replaced Modem Sign On configuration parameter with Host Sign On. (Language
Conversions needed)
Added TDS 3PO interface routines.
In process: Adding Krohne and Micromotion functionality
Removed ILTA Mass Meter demo code.
Added Mass Meter Real Time Status Registers.
Added VOLUME_KROHNE(3) and VOLUME_MICROMOTION(4) to meter type enumeration.
Added MASS MTR to the Communication Setup port type.
Added Mass Meter Diagnostics to Meter Diagnostic Screen.
Corrected bug where the input of UNSIGNED_DIV1000 formatted parameters accepted
the selection of a sign.
Removed workaround to force state to idle when power up and a transaction is
completing.
Added SD Card Functions.
Added SD Card selection to the Views and Inquiries Menu.
Changed firmware version to 3/4.30.00.
Changed real time database version to 3.30.00.
12/20/10 3/4.30.00 WJP
Added new Calculations for Shell Canada and Measurement Canada V18.
For Side Stream Calculations: